Comments on: 64-73 Mustang MOD 1 Rear Suspension Kit

By: Grant Folstad

Grant Folstad — Wed, 05 Jul 2023 17:37:32 +0000

I installed this on my 1968 Mustang to replace the old stock leaf springs. At the same time, I also installed Mike’s subframe connectors and the X brace. The installation was smooth, I reached out to Mike Maier Inc a time or two with questions and they were very helpful with answering my questions. I use my car mainly for cruising with an occasional burnout or two. The car handles much nicer now, and it just squats and goes under hard acceleration. I installed a 2.5″ dual exhaust after I put the above-mentioned parts in. The X brace and Panhard bracket make installing the exhaust a little more challenging, but it was my first custom exhaust fab and I was able to make it all fit well. I’m very happy with the results and these parts are built very well. Thank you!

By: Grant Hodgkins

Grant Hodgkins — Fri, 29 Apr 2022 14:50:26 +0000

This kit is Fantastic and looks great! Installation wasn’t too bad, definitely harder to find a welder than the actual prep and installation. If you are tired of a sloppy old rear end like me, tighten it up with this kit!

By: guys72mach1

guys72mach1 — Sun, 10 Jan 2021 03:08:00 +0000

Unbelievably difference. Unbelievable!! Rear end back snaps into place, car squats and go’s instead of fishtailing. Astounded at the improvement the MOD1 rear suspension kit made

By: meeks.richard

meeks.richard — Wed, 11 Nov 2020 03:21:54 +0000

Fits awesome, quality product!